Ipod nano 1 battery

Enter your email address below, and we will notify you when this product is back in stock. This iPod nano 1st Gen replacement battery is what you need to bring your dead iPod back to life! Battery degradation is an inevitable part of your iPod's lifespan — extend it with this new replacement battery compatible with the first generation iPod nano, ipod nano 1 battery.

I recently found an old iPod Nano 1st Generation that was sitting in a drawer, collecting dust since around or When it was in use, it was slightly damaged with a small dent on one side of the back. I also noticed the back was slightly coming off on the opposite side of the dent, but I assumed it was just because of the dent. Upon charging it, the opening got somewhat worse, so I unplugged it remember pin? Not only have I never really opened a piece of Apple technology this small, but I am also not really willing to remove the battery due to risk of fire or explosion. I have no replacement batteries, but this iPod is nostalgic to me and I would like to avoid throwing it away until it is absolutely necessary.

Ipod nano 1 battery

The rear panel is secured to the front case by eleven clips permanently attached to the rear panel. These clips lock onto small tabs machined into the front case. To free the tabs, they must be pushed down and away from the iPod's case. Note the location of all tabs on the rear panel. When using an iPod opening tool to free the rear panel, be sure to work the tool at the location of these clips. Opening the iPod can be challenging. Don't get discouraged if it takes you a few tries before the iPod is opened. Insert the large iPod opening tool into the seam between the front case and rear panel of the iPod, below the dock connector. Run the tool back and forth to create an opening. The tool's edge should point toward the rear panel to prevent any accidental scratching of the aluminum front case. Insert a small iPod opening tool into the seam on the Hold button side of the iPod, with the edge of the tool pointing toward the rear panel. The large iPod opening tool is no longer needed to gain access to the left side of the iPod. Repeat the same procedure listed in the previous step to free the five clips along the headphone jack side of the iPod. During reassembly, make sure to put back any tape or plastic you remove.

You're Finished! Uwe von Ditfurth - Mar 21, Reply.

.

On September 7th, , Apple announced the iPod Nano with Steve Jobs pointing to the small watch pocket in his jeans and asking, "Ever wonder what this pocket is for? The iPod Nano was the successor to the iPod Mini. This was a very risky move for Apple as the iPod Mini was selling extremely well. This risky move turned out to be the correct decision and Apple went on to sell millions of the iPod Nano-lineup. On the 11th November , Apple issued recall program for all first generation Nanos, since there were incidents involving iPod Nano 1st gens that caught on fire. Apple stated that defective batteries would cause overheating issues that could, in rare instances, make your iPod Nano 1st generation catch on fire. Owners could get the latest iPod Nano for free when they exchanged their 1st Gen. This issue appears to be caused by the placement of the battery inside of the iPod nano. Other iPod nano's suffer from a similar issue nicknamed "The Black Spot". This issue occurs in most nanos because the battery is placed behind the screen, and when the battery expands due to the release of gases trapped inside the battery as it ages it presses against the screen, pushing it out, and marking the screen with a black spot.

Ipod nano 1 battery

This instructable goes over how to change the battery in your 1st Gen Ipod Nano. This ipod was found in the junk pile at instructables with a bloated battery. Next time your friend throws out their old ipod, try to fix it up! You need a bit of supplies to complete this: A Broken iPod New Battery Soldering Iron a note on batteries, you can get them off of ebay, but i got mine from iFixit. First you need to make room for the new battery, do this by desoldering the old one from the logic board. Next carefully solder the new battery onto the board, the order from the left side of the back of the ipod is: White Red Black. Lastly close the ipod back up by snapping it together and charge it! Easy right? Well not exactly, it seems that this ipod had a bit more problems than a broken battery, after charging and trying to get it to work in diagnositc mode i got the second image: a total hard drive space of But the battery works!

Dog adoption trivandrum

Repair with confidence All our products meet rigorous quality standards and are backed by industry-leading guarantees. Too hasty repair In order to avoid damage, lift the solder tip off the connection as soon as the solder melts and the lead slides out. Use a spudger to flip up the black plastic tab holding the orange click wheel ribbon in place. Do not attempt to handle the battery yourself as it is now in poor condition and further bending, squeezing or puncturing of it is definitely not good! View Statistics:. Your repairs are in good hands! This product can expose you to chemicals including lead which is known to the State of California to cause cancer and birth defects or other reproductive harm. Mako Driver Kit - 64 Precision Bits. Show more Less. A forum where Apple customers help each other with their products. Installation requires soldering to the logic board. Using a pair of tweezers, insert the stripped ends of the battery leads into their respective holes. Page content loaded. Rotate the battery toward the logic board and place it flat in its void, bending the cables as necessary.

However, a variety of more affordable third-party services also are available.

Notify me when it is back in stock! Step 3. Replacement Guides. The battery is still soldered to the logic board by three wires, so don't remove it entirely. When using an iPod opening tool to free the rear panel, be sure to work the tool at the location of these clips. I no longer plan to use it, but I would like to keep it in a safe space with the battery fully removed and disposed of. If the battery is expanding, is this ipod going to be the cause of my house burning down? Kit contents. I skipped steps 8,9,, and The instructions were clear and helpful. What are my options?