Hunter node-100 manual turn on

Hide thumbs Also See for Node : Instructions 3 pages. Table Of Contents.

Manual Watering allows the user to activate a single station for a specified run time or activate an entire program. The weather sensor condition if used will be disregarded in the manual single station mode. Contact Support. Node - Manual Watering. Press and hold the right arrow button until the icon is displayed.

Hunter node-100 manual turn on

.

We're here.

.

Hide thumbs Also See for Node : Instructions 3 pages. Table Of Contents. Table of Contents. Quick Links. Previous Page. Next Page. Each item will be discussed in further detail later. Main Display — Indicates all program information However, this section can be helpful in getting acquainted with the different options available.

Hunter node-100 manual turn on

Table of Contents. Available languages. Quick Links. Owner's manual and programming instructions.

Ikea doors for billy

Print page 1 Print document 20 pages. The station numbers are identified on the face of the NODE. Verify that controller is programmed for start at start time. The weather sensor condition if used will be disregarded in the manual single station mode. We're here. If something is flashing on the display then permanent memory in the controller, to be restored at any time. To stop the Manual watering cycle press the minus button until the time is reduced to zero. Previous article Seasonal Adjustment. Contact Support. The controller will display a countdown and activate desired station. Pressing the right arrow button when a station is running in manual watering will stop irrigation on the current station and advance to the next station. Press the button until the icon is displayed. Restore password.

This section provides an overview of some of the components of the NODE. Each item will be discussed in further detail later.

Next Page. We're here. Restore password. Contact Support. Rename the bookmark. Upload from URL. Node - Manual Watering. The program letter A, B, or C will be displayed. A protective rubber cover is provided to prevent dirt from weather conditions dictate. If a different program is needed, quickly press the PRG button until the desired program is displayed. Press the button to proceed to the next programming function or allow controller to return to idle mode. Page Troubleshooting Guide Faulty solenoid.

2 thoughts on “Hunter node-100 manual turn on

Leave a Reply

Your email address will not be published. Required fields are marked *