D link dir 615 reset

On this page I will be showing you how to reset the Dlink DIR router back to it's original factory defaults. Before I do that I want to explain the difference between two easily confused terms.

To perform a factory reset, please follow the steps below. Step 1: With the unit on, place a paper clip into the hole on the back of the unit labeled Reset. Step 2: Hold paper clip down for 10 seconds and release. Step 3: The unit will reboot on its own. Once the WLAN light stops blinking, the unit is reset.

D link dir 615 reset

D-Link Forums. Please login or register. I have a DIR that is not responding to hard resets. It was working fine for about a week and then stopped handing out IP's to wireless clients. I attempted a powercycle and when the router came back up the wireless light was no longer on and it was no longer handing out IP's to ethernet clients. The power light is solid, internet light lights up when connected to my modem and flashes intermittently, and the ethernet lights light up in response to connecting clients. I have attempted to hard reset the router to no avail. I also tried statically assigning Anyone else have this issue? Anyone been able to fix this? It is hardware version A1 Firmware version 1. When you reset the router did you do it with the power on and hold the button down for at least 10 seconds?

Read Answer How do I view which websites have visited through my mydlink router? Any other ideas?

.

Table Of Contents. Table of Contents. Previous Page. Next Page. Page 3 Check your IP address Actual data throughput will vary.

D link dir 615 reset

D-Link Forums. Please login or register. I have a DIR that is not responding to hard resets. It was working fine for about a week and then stopped handing out IP's to wireless clients.

Kenken solver

Remember this reset erases every single setting you have ever changed on this device. We also have the following guides for the same router:. The last thing to check is the WiFi settings. Routers Networking Software. It was working fine for about a week and then stopped handing out IP's to wireless clients. It is not, sadly, under warranty. I also tried statically assigning Also wait about 30 seconds before you try to connect to the status page after the reset. Please login or register. The first step in a reset is to find the reset button. Next you'll need to log into your Dlink DIR router. I think I got mine half a year or a year ago, and now it did the same thing this guy is saying. I have also waited several minutes before attempting to access the status page. Anyone else have this issue? Thanks again for the suggestions.

.

I attempted a powercycle and when the router came back up the wireless light was no longer on and it was no longer handing out IP's to ethernet clients. Sounds like it has died. Post the results and perhaps someone can help you get the connection to the internet going - I assume that is the problem "not working" isn't very specific ;- Also, provide your hardware version and the firmware version. These may also help:. While the router is on take the end of a paperclip and press down on the reset button for about 10 seconds. Any other ideas? Get Software. The last thing to check is the WiFi settings. Please login or register. When you reset this router you take all the settings and return everyone of them back to factory defaults. The next thing to do is log in to the router at I used the reset button, I turned off the power and I used a toothpick in the hard reset switch the little hole on the far right at the back. On the other hand my DIR only requires a light touch to reset it. Read Answer What is the button on the side of my router used for?